Forum Debian Users Gang

blacklist ipv6

blacklist ata_piix

# prevent unnecessary modules from being loaded (you don't need to do this)
blacklist ata_generic
blacklist libata
blacklist scsi_mod

$$$$$$$$$$$$$$$$$$$$$$$$4

# List of modules that you want to include in your initramfs.
# They will be loaded at boot time in the order below.
#
# Syntax:  module_name [args ...]
#
# You must run update-initramfs(8) to effect this change.
#
# Examples:
#
# raid1
# sd_mod


piix
ide_generic
ide_cd
ide_disk

# blacklist bad driver
blacklist ata_piix

# prevent unnecessary modules from being loaded (you don't need to do this)
blacklist ata_generic
blacklist libata
blacklist scsi_mod

I've solved the problem editing /etc/initramfs-tools/modules, and adding this lines:

piix
ide_generic
ide_cd
ide_disk

# blacklist bad driver
blacklist ata_piix

# prevent unnecessary modules from being loaded (you don't need to do this)
blacklist ata_generic
blacklist libata
blacklist scsi_mod

after editing:

sudo update-initramfs -u

after reboot I have my hard disks with the old fashioned /dev/hd*, without bugs!!!

Chodzi o plik /etc/modprobe.d/blacklist.conf.

# This file lists modules which will not be loaded as the result of
# alias expansion, with the purpose of preventing the hotplug subsystem
# to load them. It does not affect autoloading of modules by the kernel.
# This file is provided by the udev package.

# evbug is a debug tool and should be loaded explicitly
blacklist evbug

# these drivers are very simple, the HID drivers are usually preferred
blacklist usbmouse
blacklist usbkbd

# replaced by e100
blacklist eepro100

# replaced by tulip
blacklist de4x5

# replaced by tmscsim
blacklist am53c974

# these watchdog drivers break some systems
blacklist iTCO_wdt

     blacklist vga16fb
     blacklist nouveau
     blacklist rivafb
     blacklist nvidiafb
     blacklist rivatv

blacklist libata
blacklist scsi_mod
blacklist ata_piix

    blacklist ata_piix

Faktycznie używasz tego sterownika czy skopiowałeś z tamtego wątku?

hdparm -tT /dev/sda8

/dev/sda8:
 Timing cached reads:   282 MB in  2.01 seconds = 140.57 MB/sec
 Timing buffered disk reads:  42 MB in  3.01 seconds =  13.96 MB/sec

W jaju masz dwie gałęzie sterowników: IDE i libata. IDE to te przestarzałe których chcesz używać, a libata to te nowe których generalnie teraz się używa. Żeby używać tych przestarzałych musisz pozbyć się wszystkich modułów ładowanych z gałęzi libata (z samym libata włącznie) i zastąpić je odpowiednikami z gałęzi IDE.

a co to za dysk i jakich parametrów nie możesz ustawić?