Forum Debian Users Gang

To chyba jednak nalog, jak mam wolna chwile to musze grzebac w Debianie a pozniej prosic Was o pomoc.
Tym razem zainstalowalem:
- Host (Jessie)
- VM Virtualbox:
  - 2 sieci
  - 2 interfejsy
    - Ad1 - bridged.
    - Ad2 - internal
- pfSense (Guest) na VM VB.
  - 2 interfejsy:
    - em0 (WAN)
    - em1 (LAN)
Korzystalem min z tego tutoriala: http://rumyittips.com/how-to-install-pfsense-in-virtualbox/ i wielu innych.

Rozwiazanie problemu jest tutaj, tylko nie jestem pewien czy do konca dobrze rozumiem.

Your lan got that via dhcp.. That is not something lan is normal gotten from anyway because normally you run dhcpd on pfsense, etc. etc.. and it needs to be static.

If you want to run this for your whole network then do this.. Your box needs 2 interfaces min or smart switch and vlans but then gets way more complicated.

Interface your going to connect to your internet - wan, would be bridge in VB. Your Lan side interface in PC would be bridged in VB.
In your PC that is running vb you would not have any binding to the wan nic.
Your PC would have an IP on the lan side bridge interface in vb..

Your pfsense vm in vb would have virt nic connected to your phy wan interface that is bridged and get your public IP from your ISP or if behind nat some rfc1918 from your gateway/router from your ISP. Your lan side network or lan interface in vb would be some different network that is bridged to your lan side PC interface. This would be connected to your phy switching setup. All other devices would be connected here, wireless AP would be connected here.

Your PC would have IP on this network.. This is what it would use for internet access.

My router - 192.168.0.1
My host - 192.168.0.182
pfSense WAN - 192.168.0.48

Well your host is on the pfsense WAN.. As I showed in the my setup your PC running vm IP should be on the interface that is bridged to pfsense lan and your network - can not be connected to your routers network. Do this your going to need another switch. Can not just have 1 router as your only connection.

https://forum.pfsense.org/index.php?action=dlattach … h=96098;image
Caly watek jest tutaj: https://forum.pfsense.org/index.php?topic=126486.0
Zeby filtrowac siec i uzyc "goscia" pfSense jako firewall musze miec 2 interfejsy, to wiem, probowalem na rozne konfigi i ciagle brak dostepu do webConfiguratora.
Jak zestawic takie polaczenie w praktyce?

Ostatnio edytowany przez Novi-cjusz (2017-03-04 16:47:40)