Forum Debian Users Gang

lspci -vv
00:01.0 PCI bridge: VIA Technologies, Inc. VT8633 [Apollo Pro266 AGP] (prog-if 00 [Normal decode])
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx-
        Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort+ >SERR- <PERR+ INTx-
        Latency: 0
        Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
        Memory behind bridge: e4000000-e5ffffff
        Prefetchable memory behind bridge: e0000000-e3ffffff
        Secondary status: 66MHz+ FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort+ <SERR- <PERR+
        BridgeCtl: Parity- SERR- NoISA+ VGA+ MAbort- >Reset- FastB2B-
                PriDiscTmr- SecDiscTmr- DiscTmrStat- DiscTmrSERREn-
        Capabilities: [80] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-
        Kernel modules: shpchp

00:11.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) (prog-if 8a [Master SecP PriP])
        Subsystem: VIA Technologies, Inc. Device aa01
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 32
        Interrupt: pin A routed to IRQ 5
        Region 0: [virtual] Memory at 000001f0 (32-bit, non-prefetchable) [size=8]
        Region 1: [virtual] Memory at 000003f0 (type 3, non-prefetchable) [size=1]
        Region 2: [virtual] Memory at 00000170 (32-bit, non-prefetchable) [size=8]
        Region 3: [virtual] Memory at 00000370 (type 3, non-prefetchable) [size=1]
        Region 4: I/O ports at d000 [size=16]
        Capabilities: [c0] Power Management version 2
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-
        Kernel driver in use: pata_via
        Kernel modules: pata_via

00:14.0 Mass storage controller: Promise Technology, Inc. PDC20375 (SATA150 TX2plus) (rev 02)
        Subsystem: Promise Technology, Inc. PDC20375 (SATA150 TX2plus)
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 96 (1000ns min, 4500ns max), Cache Line Size: 576 bytes
        Interrupt: pin A routed to IRQ 12
        Region 0: I/O ports at dc00 [size=64]
        Region 1: I/O ports at e000 [size=16]
        Region 2: I/O ports at e400 [size=128]
        Region 3: Memory at e7421000 (32-bit, non-prefetchable) [size=4K]
        Region 4: Memory at e7400000 (32-bit, non-prefetchable) [size=128K]
        [virtual] Expansion ROM at 20000000 [disabled] [size=16K]
        Capabilities: [60] Power Management version 2
                Flags: PMEClk- DSI+ D1+ D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-
        Kernel driver in use: sata_promise
        Kernel modules: sata_promise

lsmod
Module                  Size  Used by
nfsd                  191039  11
lockd                  49101  1 nfsd
nfs_acl                 1695  1 nfsd
auth_rpcgss            24892  1 nfsd
sunrpc                133436  9 nfsd,lockd,nfs_acl,auth_rpcgss
exportfs                2526  1 nfsd
ext4                  250398  1
jbd2                   54715  1 ext4
crc16                   1027  1 ext4
fuse                   43130  1
padlock_aes             4295  0
aes_generic            25738  1 padlock_aes
via_rng                 1085  0
rng_core                2178  2 via_rng
vt1211                  9728  0
hwmon_vid               1504  1 vt1211
loop                    9609  0
usbhid                 27360  0
hid                    50405  1 usbhid
evdev                   5581  0
i2c_viapro              4383  0
parport_pc             15799  0
parport                22526  1 parport_pc
i2c_core               12540  1 i2c_viapro
button                  3586  0
processor              25439  1
ehci_hcd               26714  0
uhci_hcd               15709  0
firewire_ohci          16425  0
serio_raw               2920  0
floppy                 40843  0
shpchp                 21220  0
sata_promise            7177  1
usbcore                96165  4 usbhid,ehci_hcd,uhci_hcd
via_rhine              14166  0
firewire_core          30503  1 firewire_ohci
via_ircc               13231  0
mii                     2714  1 via_rhine
nls_base                4541  1 usbcore
pci_hotplug            18065  1 shpchp
crc_itu_t               1035  1 firewire_core
irda                   75720  1 via_ircc
crc_ccitt               1039  1 irda
ext3                   93133  5
jbd                    31605  1 ext3
mbcache                 3766  2 ext4,ext3
sd_mod                 25601  9
crc_t10dif              1012  1 sd_mod
thermal                 9198  0
fan                     2590  0
thermal_sys             9378  3 processor,thermal,fan
ata_generic             2015  0
pata_via                5577  6
libata                113120  3 sata_promise,ata_generic,pata_via
scsi_mod              100576  2 sd_mod,libata

  │ Symbol: IDE [=n]   
  │ Type  : tristate                 
  │ Prompt: ATA/ATAPI/MFM/RLL support (DEPRECATED)  
  │   Defined at drivers/ide/Kconfig:9         
  │   Depends on: HAVE_IDE [=y] && BLOCK [=y]          
  │   Location:                         
  │     -> Device Drivers

  │ Symbol: ATA [=y]          
  │ Type  : tristate       
  │ Prompt: Serial ATA and Parallel ATA drivers    
  │   Defined at drivers/ata/Kconfig:5   
  │   Depends on: HAS_IOMEM [=y] && BLOCK [=y] && (!M32R && !M68K || BROKEN [=n])  
  │   Location:            
  │     -> Device Drivers       
  │   Selects: SCSI [=y]