Forum Debian Users Gang

##### IEEE 802.11n related configuration ######################################

# ieee80211n: Whether IEEE 802.11n (HT) is enabled
# 0 = disabled (default)
# 1 = enabled
# Note: You will also need to enable WMM for full HT functionality.
#ieee80211n=1

# ht_capab: HT capabilities (list of flags)
# LDPC coding capability: [LDPC] = supported
# Supported channel width set: [HT40-] = both 20 MHz and 40 MHz with secondary
#    channel below the primary channel; [HT40+] = both 20 MHz and 40 MHz
#    with secondary channel below the primary channel
#    (20 MHz only if neither is set)
#    Note: There are limits on which channels can be used with HT40- and
#    HT40+. Following table shows the channels that may be available for
#    HT40- and HT40+ use per IEEE 802.11n Annex J:
#    freq        HT40-        HT40+
#    2.4 GHz        5-13        1-7 (1-9 in Europe/Japan)
#    5 GHz        40,48,56,64    36,44,52,60
#    (depending on the location, not all of these channels may be available
#    for use)
#    Please note that 40 MHz channels may switch their primary and secondary
#    channels if needed or creation of 40 MHz channel maybe rejected based
#    on overlapping BSSes. These changes are done automatically when hostapd
#    is setting up the 40 MHz channel.
# Spatial Multiplexing (SM) Power Save: [SMPS-STATIC] or [SMPS-DYNAMIC]
#    (SMPS disabled if neither is set)
# HT-greenfield: [GF] (disabled if not set)
# Short GI for 20 MHz: [SHORT-GI-20] (disabled if not set)
# Short GI for 40 MHz: [SHORT-GI-40] (disabled if not set)
# Tx STBC: [TX-STBC] (disabled if not set)
# Rx STBC: [RX-STBC1] (one spatial stream), [RX-STBC12] (one or two spatial
#    streams), or [RX-STBC123] (one, two, or three spatial streams); Rx STBC
#    disabled if none of these set
# HT-delayed Block Ack: [DELAYED-BA] (disabled if not set)
# Maximum A-MSDU length: [MAX-AMSDU-7935] for 7935 octets (3839 octets if not
#    set)
# DSSS/CCK Mode in 40 MHz: [DSSS_CCK-40] = allowed (not allowed if not set)
# PSMP support: [PSMP] (disabled if not set)
# L-SIG TXOP protection support: [LSIG-TXOP-PROT] (disabled if not set)
#ht_capab=[HT40-][SHORT-GI-20][SHORT-GI-40]

ieee80211n: Set to 1 to enable 802.11n support, 0 to disable it 
ht_capab: A list of the 802.11n features supported by your device

# Debugging: 0 = no, 1 = minimal, 2 = verbose, 3 = msg dumps, 4 = excessive
debug=0