Nie jesteś zalogowany.
Jeśli nie posiadasz konta, zarejestruj je już teraz! Pozwoli Ci ono w pełni korzystać z naszego serwisu. Spamerom dziękujemy!
Prosimy o pomoc dla małej Julki — przekaż 1% podatku na Fundacji Dzieciom zdazyć z Pomocą.
Więcej informacji na dug.net.pl/pomagamy/.
Potrzebuję zasięgnąć waszej opinii, aby być 100% pewnym.
Do rzeczy:
Zamówiłem nowy dysk HGST 500 GB (edycja - 320GB, mój błąd). Dostawca wyraźnie zaznaczył, że dysk jest nowy, z zerowym przebiegiem.
Generalnie każdy dysk, który do mnie przychodzi zostaje poddany testowi SMART.
Wycinek testu smart:
9 Power_On_Hours 0x0032 100 100 000 Old_age Always - 0
Ok, pokazuje 0 godzin, czyli dysk jest niby nowy, ale...
Historia testów SMART mówi już co innego
# 2 Short offline Completed without error 00% 2232
Tu już widać nalot 2232 godzin, a po dalszym zagłębieniu się widać coś takiego:
Error 160 occurred at disk power-on lifetime: 3693 hours (153 days + 21 hours)
Po odpaleniu smartctl -t short wynik mojego testu to już:
# 1 Short offline Completed without error 00% 0 -
Jakieś wnioski drodzy koledzy? Dysk kręcony niczym niemiecki passat w tdi, czy tylko jakieś błędy samego SMART?
/edycja
Dysk ma 320GB a nie 500GB, mój błąd
Ostatnio edytowany przez krasnij (2017-08-28 16:36:16)
Offline
A proszę uprzejmie
SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x002f 100 100 062 Pre-fail Always - 0 2 Throughput_Performance 0x0025 100 100 040 Pre-fail Offline - 0 3 Spin_Up_Time 0x0023 100 100 033 Pre-fail Always - 1 4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 1 5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always - 0 7 Seek_Error_Rate 0x002f 100 100 067 Pre-fail Always - 0 8 Seek_Time_Performance 0x0025 100 100 040 Pre-fail Offline - 0 9 Power_On_Hours 0x0032 100 100 000 Old_age Always - 0 10 Spin_Retry_Count 0x0033 100 100 060 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 1 183 Runtime_Bad_Block 0x0032 100 100 000 Old_age Always - 0 184 End-to-End_Error 0x0033 100 100 097 Pre-fail Always - 0 187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 0 188 Command_Timeout 0x0032 100 100 000 Old_age Always - 1 190 Airflow_Temperature_Cel 0x0022 076 075 045 Old_age Always - 24 (Min/Max 20/24) 191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 0 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 65537 193 Load_Cycle_Count 0x0032 100 100 000 Old_age Always - 1 196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 0 197 Current_Pending_Sector 0x0032 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0030 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x0036 100 100 000 Old_age Always - 0 223 Load_Retry_Count 0x002a 100 100 000 Old_age Always - 0 SMART Error Log Version: 1 ATA Error Count: 160 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 160 occurred at disk power-on lifetime: 3693 hours (153 days + 21 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 51 01 7f bd 5b 00 Error: ICRC, ABRT at LBA = 0x005bbd7f = 6012287 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 08 b0 78 bd 5b 40 00 00:08:17.445 WRITE FPDMA QUEUED 60 18 a8 98 2e 14 40 00 00:08:17.438 READ FPDMA QUEUED 60 03 a0 0a 68 06 40 00 00:08:17.437 READ FPDMA QUEUED 60 3b 98 08 67 06 40 00 00:08:17.437 READ FPDMA QUEUED 60 3b 90 cd 66 06 40 00 00:08:17.437 READ FPDMA QUEUED Error 159 occurred at disk power-on lifetime: 3693 hours (153 days + 21 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 51 11 77 bb ff 0b Error: ICRC, ABRT at LBA = 0x0bffbb77 = 201309047 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 40 78 08 57 e0 40 00 00:05:04.169 READ FPDMA QUEUED 61 00 70 20 76 27 40 00 00:05:04.169 WRITE FPDMA QUEUED 61 00 68 20 75 27 40 00 00:05:04.169 WRITE FPDMA QUEUED 61 00 60 20 74 27 40 00 00:05:04.169 WRITE FPDMA QUEUED 61 00 58 20 73 27 40 00 00:05:04.169 WRITE FPDMA QUEUED Error 158 occurred at disk power-on lifetime: 3693 hours (153 days + 21 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 51 10 78 bb ff 0b Error: ICRC, ABRT at LBA = 0x0bffbb78 = 201309048 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 78 20 76 27 40 00 00:05:04.107 WRITE FPDMA QUEUED 61 00 70 20 75 27 40 00 00:05:04.107 WRITE FPDMA QUEUED 61 00 68 20 74 27 40 00 00:05:04.107 WRITE FPDMA QUEUED 61 00 60 20 73 27 40 00 00:05:04.107 WRITE FPDMA QUEUED 61 00 58 20 72 27 40 00 00:05:04.107 WRITE FPDMA QUEUED Error 157 occurred at disk power-on lifetime: 3693 hours (153 days + 21 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 51 10 78 bb ff 0b Error: ICRC, ABRT at LBA = 0x0bffbb78 = 201309048 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 78 20 76 27 40 00 00:05:04.060 WRITE FPDMA QUEUED 61 00 70 20 75 27 40 00 00:05:04.060 WRITE FPDMA QUEUED 61 00 68 20 74 27 40 00 00:05:04.060 WRITE FPDMA QUEUED 61 00 60 20 73 27 40 00 00:05:04.060 WRITE FPDMA QUEUED 61 00 58 20 72 27 40 00 00:05:04.060 WRITE FPDMA QUEUED Error 156 occurred at disk power-on lifetime: 3693 hours (153 days + 21 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 51 10 08 bb ff 0b Error: ICRC, ABRT at LBA = 0x0bffbb08 = 201308936 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 00 30 20 69 27 40 00 00:05:04.029 WRITE FPDMA QUEUED 61 00 28 20 68 27 40 00 00:05:04.029 WRITE FPDMA QUEUED 61 00 20 20 67 27 40 00 00:05:04.029 WRITE FPDMA QUEUED 61 10 18 98 ba ff 40 00 00:05:04.029 WRITE FPDMA QUEUED 60 40 10 90 20 42 40 00 00:05:04.028 READ FPDMA QUEUED SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 0 - # 2 Short offline Completed without error 00% 2232 - # 3 Extended offline Completed without error 00% 2231 - # 4 Short offline Completed without error 00% 2230 - # 5 Short offline Completed without error 00% 3 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing
Offline
ihmo dysk miał czyszczonego smarta ale coś nie wszystko udało się usunąć, jest bardzo dużo parkowań dysku
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 65537
I sam fakt, że są wykryty błędy
Error 160 occurred at disk power-on lifetime: 3693 hours (153 days + 21 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 51 01 7f bd 5b 00 Error: ICRC, ABRT at LBA = 0x005bbd7f = 6012287 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 08 b0 78 bd 5b 40 00 00:08:17.445 WRITE FPDMA QUEUED 60 18 a8 98 2e 14 40 00 00:08:17.438 READ FPDMA QUEUED 60 03 a0 0a 68 06 40 00 00:08:17.437 READ FPDMA QUEUED 60 3b 98 08 67 06 40 00 00:08:17.437 READ FPDMA QUEUED 60 3b 90 cd 66 06 40 00 00:08:17.437 READ FPDMA QUEUED
Offline
Dysk nie jest nowy, miał poprostu niedokładnie wyczyszczonego smarta.
Przy błędach typu
"Error xxx occured at disk ................."
Pierwsze co robie to planuje okienko serwisowe by go wymienić - i tobie to samo radze, bo przy nowych to on może tylko leżał :)
Offline
Error 160 occurred at disk power-on lifetime: 3693 hours (153 days + 21 hours)
Nowy dysk z zerowym przebiegiem ma 3693h na liczniku?
Opisz oszusta na necie, ciekawe, ile osób skutecznie oszukał przed Tobą.
Offline